You asked: How do I change the assembly mass in Solidworks?

How do I change density in Solidworks 2019?

In a part document, click Options or Tools > Options. On the Document Properties tab, click Material Properties. Type the material density in the Density box. You can type the density value with any units.

How do you override mass in Solidworks?

Click Tools > Evaluate > Mass Properties and then, in the Mass Properties dialog box, click Override Mass Properties.

How do I change density in Solidworks 2018?

Modify the measurement units and the material density used by the Mass Properties and Section Properties tools. To modify measurement units and material density: Click Options in the Mass Properties or Section Properties dialog box, select from the following options, then click OK.

How does solidworks calculate mass?

Select items (components or solid bodies) to be evaluated. If no component or solid body is selected, the mass properties for the entire assembly or part are reported. Click Mass Properties (Tools toolbar) or Tools > Evaluate > Mass Properties. The calculated mass properties appear in the dialog box.

How do I add a point mass in SOLIDWORKS?

You add a COM point by clicking Center of Mass (Reference Geometry toolbar) or Insert > Reference Geometry > Center of Mass. In the graphics area, appears at the center of mass of the model.

IT IS INTERESTING:  Question: Is C used for CAD?

How do I change units in SOLIDWORKS?

Go to Tools>Options>Document Properties>Units to change the units that are being used within the SOLIDWORKS design environment. There is also the units’ popup menu in the bottom right-hand corner of the SOLIDWORKS screen.

How do I change material properties in SOLIDWORKS?

To assign/modify a material to a part:

  1. Click Choose Material (Material tab of the SimulationXpress wizard).
  2. In the Material dialog box, expand the class of materials and select a material.
  3. Click Apply.
  4. Click Close. The material appears in the SimulationXpress wizard and a check mark appears next to Material. …
  5. Click Next.

How does SOLIDWORKS calculate model weight?

The mass properties of a part or assembly can be found by going to the evaluate tab and clicking on the icon labeled Mass Properties. The mass properties of a part/assembly can also be found by going to Tools>Evaluate>Mass Properties as shown below.

How do you create a clip in Solidworks?

To create a clip for auto-routing: Create a model of the clip. Add any mate references you might need to position the clip in an assembly.



Create sketch points to locate the route points:

  1. Open a sketch on a side face of the clip, as shown.
  2. Click Point. …
  3. Close the sketch.
  4. Repeat steps a to c on the opposite face.
All about design