Your question: How do you cut Toposurface in Revit?

How do you edit Toposurface in Revit?

Add points for accuracy if needed.

  1. Click Modify | Topography tab Surface panel (Edit Surface).
  2. Click Edit Surface tab Tools panel (Simplify Surface).
  3. Open the site plan view and select the toposurface.
  4. Enter a value for surface accuracy, and click OK.
  5. Click (Finish Surface).

How do you cut and fill topography in Revit?

View the Cut/Fill Volumes

  1. Create a toposurface.
  2. In the site plan view, select the toposurface.
  3. On the Properties palette, set Phase Created to a phase earlier than the view’s phase. …
  4. Optional. …
  5. Click (Finish Surface).
  6. Select the toposurface copy.

How do you cut and fill in Revit?

Report the cut and fill volumes of the graded region with a topography schedule. On the View tab, create a schedule and select the topography category. Add the cut and fill parameters to the schedule. Change the phase filter of the schedule so it does not display calculations for the existing site.

How do you create a Toposurface in Revit Architecture?

Create a Toposurface by Placing Points

  1. Open a 3D view or a site plan view.
  2. Click Massing & Site tab Model Site panel (Toposurface).
  3. On the Options Bar, set a value for Elevation. …
  4. Next to the Elevation text box, select one of the following: …
  5. Click in the drawing area to place points. …
  6. Click (Finish Surface).
IT IS INTERESTING:  Question: How do you write architecture?

How do I get topography in Revit?

In Revit, link the topography to the current model as follows:

  1. Specify coordinates for the building model. …
  2. Open a plan view or a 3D view for the building model. …
  3. Click Insert tab Link panel (Link Topography).
  4. In the Link Topography dialog, navigate to the topography. …
  5. Select the desired topography, and click Link.

Where are Revit site settings?

To access the Site Settings dialog, click the dialog launcher on the Model Sight panel. In the Site Settings dialog, you can modify the contour line display by adding contours. To do this, click Insert. Change the Start, Stop, and Increments values and select the desired Range Type and Subcategory.

All about design