How do I change units in Catia v6?

3DCS follows the CATIA units. The default unit is millimeters. To change the units, simply click the drop-down list at the bottom of the units window and select the desired unit.

How do I change units in Catia?

change the units in catia V5: Tools-> options->parameters and measures->units.

How do I change parameters in Catia?

To reorder parameters, right-click the parameter to be reordered, and select Reorder… . The Reorder dialog box is displayed. In the specification tree, click a parameter below which the parameter to be reordered will be located. Click OK when done.

How do you change units in 3dx?

To change the system unit:

  1. Choose Customize menu Units Setup.
  2. Click System Unit Setup.
  3. Change the System Unit Scale value, and click OK. The system unit is immediately reset. This setting remains in effect until you change it.

What is Catia knowledgeware?

The CATIA V5 knowledgeware solution turns implicit design methods into explicit knowledge and allow users to capture and reuse corporate know-how throughout the product lifecycle.

How do you add relationships in Catia?

Creating Sets of Relations

  1. Click the icon, the Relations. 1 (or Relations. …
  2. Click either relation creation icon. …
  3. Click OK to display the next dialog box and enter the relation body.
  4. After you have finished specifying the new relation, click OK in the editor dialog box.
IT IS INTERESTING:  How do you reload an image in Revit?

How do you create dimensions?

To create a new dimension. In Solution Explorer, right-click Dimensions, and then click New Dimension. On the Select Creation Method page of the Dimension Wizard, select Use an existing table, and then click Next.

How do you make dimensions?

Use the CREATE DIMENSION statement to create a dimension. A dimension defines a parent-child relationship between pairs of column sets, where all the columns of a column set must come from the same table. However, columns in one column set (called a level) can come from a different table than columns in another set.

How do you increase dimension arrow size in Catia?

You change this file using the standards editor. Start Catia in Admin mode and then going to Tools->Standards. The arrow size is in there.

All about design