Can you do a sweep cut in Solidworks?

Set the PropertyManager options based on the sweep cut feature. To open this PropertyManager: Open a part that has either a closed profile sketch and a sketch path, or a part with a sketch line, edge or curve on the model that you can specify as a path.

When using the swept cut feature what 2 sketches must you have?

Swept Cuts

In order to complete a swept cut, you must have a minimum of two sketches. One sketch will be the profile sketch, and this will be the outline of the cut. The second sketch needed will be the path sketch. The path sketch will control the direction of the cut.

Does sweep mean?

1 to clean or clear (a space, chimney, etc.) with a brush, broom, etc. 2 often foll by: up to remove or collect (dirt, rubbish, etc.)

How do you rotate a cut in Solidworks?

Creating Extruded or Revolved Cuts as Assembly Features

  1. Open a sketch on a face or plane, and sketch a profile of the cut. …
  2. Click Extruded Cut or Revolved Cut (Features toolbar), or click Insert > Assembly Feature > Cut , then Extrude or Revolve.
  3. Set the options as needed in the Extrude or Revolve PropertyManager.

How do you do a sweep?

Create a Sweep

  1. In the Family Editor, on the Create tab Forms panel, do one of the following. …
  2. Specify the sweep path: …
  3. On the Mode panel, click (Finish Edit Mode).
  4. Load or sketch a profile. …
  5. On the Properties palette, specify the sweep properties. …
  6. On the Mode panel, click (Finish Edit Mode).
IT IS INTERESTING:  Frequent question: Which of the following are the components of STL algorithms containers function iterators all of these?

What are the two necessary elements to create a sweep?

Two elements are required to create a sweep surface: Trajectory—Curve or curves that guide the sweep. Cross-sectional sweep profile—Curve or curves that sweep along the trajectory. ◦ One or two trajectories can be used.

Can you lose money in a sweep account?

Sweeping money into an investment account will always benefit the investment broker. … Anytime you invest, you run the risk of losing money. Money in a savings account usually doesn’t disappear. You have to understand that with sweep accounts, your excess cash is going into the market.

Who sweeps the floor is called?

Howard Behar: I have this little saying, “The person who sweeps the floor chooses the broom.” What I mean by that is the person who has a responsibility in certain areas is given authority, responsibility, and accountability.

What is revolved cut?

About a Revolved Cut. Use the Revolve tool to remove material by revolving a sketched section around a centerline. • To create a cut, use the same angle options as for protrusions.

How do you make a revolved boss in Solidworks?

To create a revolve feature: Create a sketch that contains one or more profiles and a centerline, line, or edge to use as the axis around which the feature revolves. Click one of the following revolve tools: Revolved Boss/Base (Features toolbar) or Insert > Boss/Base > Revolve.

All about design