Your question: How do you sweep a circle in Solidworks?

How do you do a sweep in SolidWorks?

To create a sweep: Sketch a closed, non-intersecting profile on a plane or a face.



Click one of the following:

  1. Swept Boss/Base on the Features toolbar or Insert > Boss/Base > Sweep.
  2. Swept Cut on the Features toolbar or Insert > Cut > Sweep.
  3. Swept Surface on the Surfaces toolbar or Insert > Surface > Sweep.

Does sweep mean?

1 to clean or clear (a space, chimney, etc.) with a brush, broom, etc. 2 often foll by: up to remove or collect (dirt, rubbish, etc.)

How do you do a sweep?

Create a Sweep

  1. In the Family Editor, on the Create tab Forms panel, do one of the following. …
  2. Specify the sweep path: …
  3. On the Mode panel, click (Finish Edit Mode).
  4. Load or sketch a profile. …
  5. On the Properties palette, specify the sweep properties. …
  6. On the Mode panel, click (Finish Edit Mode).

What are the two necessary elements to create a sweep?

Two elements are required to create a sweep surface: Trajectory—Curve or curves that guide the sweep. Cross-sectional sweep profile—Curve or curves that sweep along the trajectory. ◦ One or two trajectories can be used.

IT IS INTERESTING:  How do you create a tolerance in Solidworks?

How do you make a lofted boss in Solidworks?

How to use Lofted Boss/Base

  1. Click New. …
  2. Click Top Plane and click on Sketch.
  3. Click Circle, sketch a circle start at origin. …
  4. Exit sketch.
  5. Click Top Plane and click Features>Reference Geometry>Plane. …
  6. Click on Plane 1, click Sketch.
  7. Click Circle, sketch a circle start at origin. …
  8. Click on Plane 2, click Sketch.

What is sweep command in Autocad?

Creates a 3D solid or 3D surface by sweeping a 2D object or subobject along an open or closed path. Find. Open-ended objects create 3D surfaces, while objects that enclose an area can be set to create either 3D solids or 3D surfaces.

How many sketches do we need to use the feature lofted boss?

Sketch your profiles.



A minimum of two are required but a higher number of profiles allows you to create more complex shapes. Ideally profiles should be closed but Thin Feature Lofts can be created.

Which special sketch entity is useful but not required for a revolve feature?

What special piece of sketch geometry is useful, but not required for a revolve feature? Centerline.

Can you make a curved plane in Solidworks?

To project a curve: Click Project Curve on the Curves toolbar, or Insert > Curve > Projected. … Under Direction of Projection , select a plane, edge, sketch, or face as the direction of the projected curve. Under Projection Faces , select the cylindrical face on the model where you want to project the sketch.

How do you curve a face in Solidworks?

Face Curves PropertyManager

  1. Click Face Curves (Sketch toolbar) or Tools > Sketch Tools > Face Curves, then select a face or surface.
  2. Select a face or surface, then click Face Curves or Tools > Sketch Tools > Face Curves.
IT IS INTERESTING:  Is Catia better than Fusion 360?

How do I extend a curved surface in Solidworks?

To extend a surface:

  1. Click Extended Surface (Surfaces toolbar) or Insert > Surface > Extend.
  2. In the PropertyManager: Under Edges/Faces to Extend, select one or more edges or faces in the graphics area for Selected Face/Edges . For edges, the surface extends along the plane of the edge. …
  3. Click .
All about design